Ive seen some people saying these clone devices with a serial no.Ī green dot in the bottom-right turned red each time I tried saving something - but where does it save this data and how do I access this It would be nice to see some graphs and stuff. So if youre trying with a VM Id imagine youd need to create at least one virtual network interface, even if you leave it disconnected. I enabled one of them again (but left disconnected), rebooted, restarted DiagBox and activation worked fine. One issue I had was was DiagBox activation failed at first (Error 0 or something vague like that) - this seemed to be because I had all network interfaces disabled on my laptop. Im not sure what DiagTool does yet (wouldnt work for me), but PP2000 is where you can checkclear fault codes, get live readouts, run tests, and configure things. You may be prompted for VIN confirmation then youll be prompted for the DAM - this is the 5-digit build code number, on the sticker in the drivers door pillar on D9s (you can also get it from Service Box). Please note after installing each update youll need to reboot then run DiagBox for the update to be fully installed.Īt some stage the drivers will change and youll get the New hardware found wizard again - choose the driver manually as before (the name will be different). Diagbox Activation Error 0 Drivers Then Just.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |